Code: C-1106
Classification: FS: FS-532 abnormality
Cause:
The stapler movement home sensor (PS22) does not turn ON within a specified period of time after the home position search operation of the stapler movement motor (M14) starts.
Measures to take when alert occurs:
The main body and the option stop immediately.
Estimated abnormal parts:
- FNS control board (FNSCB)
- Stapler movement motor (M14)
- Stapler movement home sensor (PS14)
Correction:
Turn OFF/ON the sub power switch (SW2) of the main body.
Note: The message "Please call service" is displayed on the panel.
Solution:
- Check the stapler movement section, and clean/repair it if any abnormality.
- Check the connector connection and the wiring between FNSCB and motor/sensor, and repair it if any abnormality.
- Check the I/O drive of the motor and the coupling of the gear, and repair/replace it if any abnormality. (Wiring diagram: FS-532: 5-F)
- Check the I/O and the operation of the sensor, and repair/replace it if any abnormality. (Wiring diagram: FS-532: 10-B)
- Replace PS22.
- Replace M14.
- Replace FNSCB.