Code: C-0214
Classification: PF: Tray 11
Cause:
3rd tandem PF-703 lower tray up abnormality.
When the upper limit sensor/3 (PS13) is inactive, PS13 does not become active within 20 seconds after the paper lift motor/3 (M9) started the lifting operation. Alternatively, the paper suction sensor/Fr3 (PS29) and the paper suction sensor/Rr3 (PS30) become active before PS13 becomes active while the tray lifts.
Measures to take when alert occurs:
The main body and the option stop immediately.
Estimated abnormal parts:
- Upper limit sensor /3 (PS13: PF-703)
- Paper lift motor /3 (M9: PF-703)
- PF drive board (PFUDB: PF-703)
Correction:
Turn OFF/ON the power switch (SW2) of the main body when releasing an abnormal condition.
Note: "Please call service" is displayed on the touch panel.
Solution:
- Check the paper loaded condition and the rear end restricted plate misaligned of the lower tray, and repair it if any abnormality.
- Check the connector connection and the wiring between PFUDB and motor/sensor, and repair it if any abnormality.
- Check the I/O drive of the motor and the coupling of the gear, and repair or replace it if there is any abnormality. (Wiring diagram: PF-703: 19-F).
- Check the I/O and the operation of the sensor, and repair or replace it if there is any abnormality. (Wiring diagram: PF-703: 16-F).
- Replace PS13
- Replace M9
- Replace PFUDB